Put a torpedo level on top it if and adjust the box to center the bubble. If you have an assistant, there's no need to tape the box. Having identified a location for your new outlet, trace the electrical box onto the wall.
Use the height measurements from a similar outlet to set the appropriate height for your new outlet. Cut out the hole with a drywall saw.
To see all of this on video visit the drywall section of the learning curve. The outlet itself should then be screwed directly onto the box with the. If the drywall or plaster is damaged, cut a larger hole and install a box that attaches directly to a stud or joist.
Draw the outline of the back of. Tuck the wires into the box and screw the outlet into the box. The bare copper wire connects to the green screw. Install the cover plate and you're finished with this outlet. Pin On Family Handyman. Pin On Projects. Pin On Hk. Your email address will not be published. Save my name, email, and website in this browser for the next time I comment.
Skip to content Put everything in the wall and install wall plates. Wholesome Food Services Reviews. The face of these boxes will generally sit slightly above the surface of the wall. Some subplates can be mounted to this type of electrical box.
There are also standard electrical boxes, which sit flush with the wall. Most modern subplates work best with the standard box. Screwless decorative wall plates are relatively easy to install.
The plates work with most standard duplex receptacles and rocker light switches with rectangular faces. First you need to install the subplate to the outlet.
The subplate comes in two halves and is held in place with mounting straps, which are connected to either side of the outlet. To install the subplate, cut the power to the device, then simply remove the cover plate and loosen the mounting screws. Next, lift the receptacle up roughly half an inch.
Push the subplate under the mounting strap and screw the device in place. When this is done correctly, the straps will snap down firmly onto the subplate while you finish tightening the screws. Now you can install the wall plates. Each screwless wall plate has an arrow to point out which side to face up. Position the wall plate over the base with the arrow side facing the device.
Then simply snap the plates to the base. If you ever choose to replace the plates, pop them off the base by inserting a small screwdriver into the slot at the bottom. Wallplate Warehouse has more tips on how to properly install wall plates onto your light switch. Cart 0.
0コメント